Crow FW2-SIREN2EXT-8/9F 설치 매뉴얼 - 페이지 5

{카테고리_이름} Crow FW2-SIREN2EXT-8/9F에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Crow FW2-SIREN2EXT-8/9F 19 페이지. Siren system

- User Guide

Siren Unit Description

Arm/Disarm Indication by Beeps/ Flash (Jumper selection)‐See Table 1

Battery test generate every 4 hours.

Low Battery Indication by Beeps/Flash (Depends on Jumper Selection of B&C)‐

Tamper protected (Cover and Back tamper).

The Siren can be assigned to Area A or Area B by jumper selection –See Table 1

STEP 1:

FW2-TRANSCEIVER – Learning & Operating Mode for

RUNNER 2 only

It is most recommended to perform factory default before first operation;

 Press and Hold the reset push button (see button location in Figure 1).

 Connect the bus cable while pressing and holding the reset button.

 Continue to hold the reset button for several seconds till ledʹs will ﬁnish to ﬂash red &

green alternately.

 Wait until the ledʹs stops ﬂashing and then remove your ﬁnger from reset button.

 Then slide device into socket.

For installation of External Transceiver Box and receiving indications form wireless Siren ‐ the

FW2 Transceiver should be learned as well, please see and perform the following steps:



Remove the jumper.



TRANS as wireless device (e.g. P122E 1‐16E options 1‐‐‐5‐‐‐ must be ON.



Enter to P164E (learn radio device) 16E (e.g. zone 16) and start the learning process.



While the Runner beeps for indicate learning process begin, press and release the

ʺLearn/resetʺ button for one second and notice the changes over the runner system

(learning mode finish).



Make sure to close the tamper switch on the transceiver (in a case of external device

only) after the learning process ends.



Notice: zone (16) in the Runner will be used also by the wireless Sirens to display

indication of (low Battery, tamper, and supervision).

Note

The "learn/reset" push button used also for registered Siren inside the transceiver.

this case the Battery use as backup.

Alarm signal will activate the Piezo Siren and the Power LED.

The Alarm can be reset by the user by using the Control Panel keypads in case

that itʹs not reset the time out 2min/15min according Jumper D selection –see

Table 1.

See Table 1.

Signal transmitted to Transceiver: Synchronization, Acknowledge, Tamper and

Low battery.