Crow PW-16 사용자 설명서 - 페이지 5

{카테고리_이름} Crow PW-16에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Crow PW-16 6 페이지. 16 zone alarm panel

Installation Notes:

INSTALLTION COMPANY:

Company ________________________________________

Technician___________________

Installation Date__________

MONITORING COMPANY:

Account Number_________________

Phone____________________

Phone_________________

Passcode______________

programmed to require your user code and press [ENTER] to disarm.

The BYPASS Key

This key allows you to temporarily Bypass zones of your choice when

arming your panel. The Bypassed zones will go back to normal the next

time you disarm the panel. A typical example would be if you wanted to let

your pet run around in the garage when your system is armed, you could

choose to Bypass that detector (say Zone 1) from the system.

To Bypass zone 1, key in the following sequence:

[ARM] [BYPASS] 1 [ENTER]

To Bypass zone 9, key in the following sequence:

[ARM] [BYPASS] [BYPASS] 9 [ENTER]

(When the second exclude is pressed the AUX. light will glow to indicate

zones 9 - 16 can now be Bypassed)

It is advisable to vacate the secured area before the exit delay expires.

The ENTER Key

This key is used to accept a series of button presses.

If you make a mistake while entering your code, press the [ENTER] key and

start again.

Please note that 4 invalid code entries will cause an alarm activation (the

sirens will sound). This is to protect your alarm system against tampering.

The PROGRAM Key

This key is used to get into program mode. There are 2 levels of program

mode, USER mode and INSTALLER mode. For your protection, your panel

can be programmed to require your master code to allow access installer

program mode.

The PW-16 can accept as many as 24 different user codes of 1 up to 6

digits in length.

Your installer will set you up to enter your master code and from there you

can be in charge of adding or removing codes for other family members or

staff who you wish to have access.

To add a new user code:

Making sure the panel is not armed, key in the following sequence:

[PROGRAM] mastercode [ENTER]