Crow CS-47 GSM 사용자 설명서 - 페이지 9

{카테고리_이름} Crow CS-47 GSM에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Crow CS-47 GSM 20 페이지. Gsm phone line backup

3.3.2 Defining SMS Messages for Inputs

The Mobile Bridge allows the definition of different SMS messages to be

sent,

depending on the state of the input. For this reason,the Message area of

the Input

window contains two Message fields.These fields correspond to the two

possible states of an input, which are as follows:

• On –The input device is running (the input has changed from

"high" to "low")

• Off –The input device is not running (the input has changed

from "low" to "high")

To define the SMS messages to be sent for each input state, perform the

following steps:

1.Click the Input tab.

2.In the Messages area, select the Enable checkbox for each state for

which a message is to be enabled.

3.In the Message field corresponding to the enabled state, enter the SMS

message to be sent.

Note: The Chars Left field displays the permitted number of characters

remaining for each message. This is a read-only field.

4.Define the Detect time (in seconds) for the message. The Detect time is

the amount of time an event must continue in order to trigger the SMS.

5.Define the Delay time (in seconds) for the message. The Delay time is

the amount of time it takes to trigger the SMS after an event has occurred.

6.Define the Repeat time (in minutes) for the message. The Repeat time is

the interval at which the SMS is re-sent, if the status of the input does not

change.

7. In case you need an output to be activated on an input triggering choose

an output number (one of the outputs).