Argos Home New Hallingford 887/6449 조립 지침 매뉴얼 - 페이지 2
{카테고리_이름} Argos Home New Hallingford 887/6449에 대한 조립 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Argos Home New Hallingford 887/6449 16 페이지. 3 drawer bedside
페이지 인쇄
Safety and Care Advice
Important - Please read these instructions fully before starting assembly
• Warning: This unit weighs
approximately 14kgs.
Please lift with care.
• Assembly to be carried out by
a competent adult only.
• Check you have all the
components and tools listed on
pages 1, 2 and 3.
• Remove all fittings from the
plastic bags and separate them
into their groups.
• During assembly children
should be kept away from the
product due to possible risk of
injury.
• Installation shall only be
carried out exactly according to
the manufacturer's instructions
- otherwise a safety risk can
occur if incorrectly installed.
Care and maintenance
• Only clean using a damp cloth
and mild detergent, do no use
bleach or abrasive cleaners.
Tools required
Scissors
Flat-head
screwdriver
Rule
1
• Parts of the assembly will be
easier with 2 people.
• Make sure you have enough
space to layout the parts before
starting.
• Do not stand or put weight on
the product, this could cause
damage.
• Assemble the item as close to
its final position (in the same
room) as possible.
• Assemble on a soft level
surface to avoid damaging the
unit or your floor (use opened
out unit carton).
• From time to time check that
there are no loose screws on
this unit.
Cross-head
Bradawl
screwdriver
as this could damage the unit.
Only use hand screwdrivers.
• WARNING: To prevent
possible overbalancing this unit
must be secured to a wall
using the overbalance
protector kit supplied.
• Dispose of all packaging
carefully and responsibly.
• Do not use this item if any
components are missing or
damaged.
• This product should not be
discarded with household
waste. Take to your local
authority waste disposal centre.
Eye protection
(when using a
Hammer
hammer or drill)
Note: If required the next page
can be cut out and used as
reference throughout the
assembly. Keep this page with
these instructions for future
reference.
• We do not
recommend the
use of power
drill/drivers for
inserting screws,
Electric drill
(do not use for
fitting screws)