Dill Retrofit TPMS 매뉴얼 - 페이지 4

{카테고리_이름} Dill Retrofit TPMS에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Dill Retrofit TPMS 16 페이지.

The display is now in LEARN MODE and will store the cold inflation

pressure of each tire once it receives a signal from the transmitter. The

process may take up to 8 minutes. If all pressures are not received in 8

minutes, the display will shift back to the monitoring mode. The tire

positions that did not register will display 00. You will need to repeat

section 1.3.2 until a signal is received from all tire positions. Driving the

vehicle will speed up the process. When rotating, the transmitters send

a signal more frequently than when the vehicle is stationary.

If any or all tires positions do not register after performing the

Baseline Pressure setting process at least twice, or if transmitter

signals are intermittent, experimentation with an external antenna

and/or signal booster will be necessary to get the unit to function.

1.4 Using the External Antenna - RF Interference

The system has been tested to work 40 feet, along line-of-sight path

ways. However, tire construction, vehicle construction, electronic

interference and low temperatures all reduce this distance. RF signals

are subject to interference from many types of signals and products,

which can cause errors in the operation of the product. As with cell

phones and other types of electronics using RF signals, signal

interruption can occur and cause lost signal transmission.

19' COAXIAL

WIRE

ANTENNA

NOTE: THE MAGNET'S

MAGNET

STRENGTH IS VERY

STRONG AND WILL ADHERE

QUICKLY TO ANY STEEL OR

IRON OBJECT. KEEP FIN-

GERS AWAY FROM THE

BOTTOM OF THE MAGNET.

FIGURE 3

DISPLAY/RECEIVER

CONNECTOR