Argosy HD 360C 매뉴얼 - 페이지 10

{카테고리_이름} Argosy HD 360C에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Argosy HD 360C 11 페이지. Usb 2.0 3.5" external hard disk drive
Argosy HD 360C에 대해서도 마찬가지입니다: 사양 (1 페이지)

페이지 인쇄

Note:

If the hard disk in the external hard disk kit is a whole new hard disk without

any partition, when the Disk Management is opened, a 'Stop' mark indicates

this drive is an 'Unknown' type of disk (refer to the figure shown on right side).

In this situation, Windows system won't allow you to create partition with this drive. In the

meantime, you can:

♦ In Windows 2000: Windows will start up the 'Write Signature and Upgrade Disk Wizard'

immediately. You can use this 'Wizard' to initial the hard disk to the 'Basic Disk' type and

can then create partition in the drive.

♦ In Windows XP: you can right-click on the 'Stop' mark, and then click 'Initialize disk' to

initial the hard disk to the 'Basic Disk' type and can then create partition in the drive.

If the type of the hard disk drive is 'Dynamic', you must change it to the 'Basic'. To do this,

right-click on the status area (left area) of Disk 1, and then click 'Revert to Basic Disk' from the

options. Wait for few seconds, the type of the hard disk drive will be changed to 'Basic' type.

To create a new partition in the external hard disk, right-click on the right area of Disk 1, click on

'Create Partition...', the 'Create Partition Wizard' appears, click Next.

Select 'Primary partition', click Next.

Specify the size that you want this partition to be, click Next.

Assign a drive letter for this partition, please use the default value, and click Next.