Dillon Quantrol BFG 2500 사용자 설명서 - 페이지 7

{카테고리_이름} Dillon Quantrol BFG 2500에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Dillon Quantrol BFG 2500 17 페이지. Basic force gauge

Operation

Fitting

Accessories

Mounting to a

test stand

Affix either the short extension rod (30mm long) or the

long extension rod (130mm long) to the load cell

probe in the hole at the bottom of the gauge by

tightening it gently with the fingers.

Your chosen grip or accessory may now be connected

to the extension rod.

When fitting a grip ensure that it is screwed finger-

tight only. Excessive torque can damage the load

cell.

On the rear of the gauge there are two M5 threaded

holes, which can be used for mounting the gauge to a

Quantrol test stand.

Each Quantrol test stand is supplied with a dedicated

'dovetailed mounting bracket' and screws for this

purpose.

If you wish to mount the gauge to another type of

stand, ensure that the screws used are threaded into

the gauge to a maximum depth of .21 inch (5.5mm).

The final thread is peaned but if screws are fitted

beyond this depth, damage to the load cell will occur.

As shown in Figure 1 the control panel has 6 keys.

Basic Force Gauge User's Manual

Figure 1

BFG keys