Motorola D1110 Series 사용자 설명서 - 페이지 6
{카테고리_이름} Motorola D1110 Series에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Motorola D1110 Series 43 페이지. D1100 series digital cordless phones
Motorola D1110 Series에 대해서도 마찬가지입니다: 빠른 시작 매뉴얼 (2 페이지), 사양 시트 (4 페이지)
페이지 인쇄
1. Getting started
WARNING
Do not place your D1111 in the bathroom or other humid areas.
Location
You need to place your D1111 base within 2 metres of the mains power
socket and telephone socket so that the cables will reach.
Make sure it is at least 1 metre away from other electrical appliances to
avoid interference. Your D1111 works by sending radio signals between
the handset and base. The strength of the signal depends on where you
place the base. Putting it as high as possible ensures the best signal.
To wall mount your D1111 base, see "Wall mounting" on page 41.
HANDSET RANGE
The D1111 has a range of 300 metres outdoors when there is a clear line
of sight between the base and handset. Any obstruction between the
base and handset will reduce the range significantly. With the base
indoors and handset either indoors or outdoors, the range will normally
be up to 50 metres. Thick stone walls can severely affect the range.
SIGNAL STRENGTH
The
icon on your handset indicates when you are in range. When out
of range of the base, the screen shows
During call, if the handset goes out of range the handset will emit out out
of range warning tone.
If you are on a call, the line will hang up if the handset moves out of range
of the base. Move back within in range. The handset will automatically re-
connect to the base.
Setting up
IMPORTANT
The base station must be plugged into the mains power at all times. Do
not connect the telephone line cord into the wall socket until the handset
is fully charged. Only use the power and telephone cables supplied with
the product.
6
Searching...
and the
flashes.
WHICH POWER ADAPTOR?
The power adaptor with a clear connector is for the base unit and the
power adaptor with a red colour connector is for the charger unit.
Connecting up the large base
Plug the power adapter with clear connector into the socket marked
on the underside of the base and plug the other end into the mains power
wall socket and switch the power on.
Connecting the handset and charger (Multi-pack only)
If you have purchased a multiple pack, this process will need to be carried
out for all handsets and chargers:
1. Plug the power adapter with red connector into the socket marked
on the underside of the charger.
Getting started