Epson ActionDesk 4000 사양 - 페이지 10
{카테고리_이름} Epson ActionDesk 4000에 대한 사양을 온라인으로 검색하거나 PDF를 다운로드하세요. Epson ActionDesk 4000 12 페이지. Product support bulletin(s)
Epson ActionDesk 4000에 대해서도 마찬가지입니다: 제품 정보 매뉴얼 (8 페이지), 제품 지원 게시판 (1 페이지)
페이지 인쇄
EPSON ActionDesk 4000+
Option curd riser board connector pin assignments (S1)
A24 SA7
B 1 8 DFNN
B 1 9 FWRESW Cl3 S D 1 0
*Active low logic
EPSON ActionDesk 4000+ - 10
C12 SD9
Installation/Support lips
Installing Diskette Drives
Make sure that the drive type has been correctly selected in
the SETUP program.
Installing Hard Disk Drives
To take full advantage of the local bus IDE interface, your
hard disk drive must support a 32-bit data path that uses
double-word I/O.
When installing a hard disk drive, see the hard disk drive
type tables and use the auto-sensing feature in SETUP to
select the correct type number for the drive. If the
auto-sensing feature does not produce a match for the
drive, you can define your own drive type by selecting
User as the type and entering the drive's exact
parameters.
Make sure you have installed the local bus IDE drivers on
your hard disk and that the CONFIG.SYS file loads the
drivers.
If you install the IDE drivers and also install Paradox for
Windows or a SCSI drive, Windows may not run correctly.
It is recommended that a 16-bit, AT-type hard disk
controller be used if you are installing a drive that cannot
use the embedded IDE interface. If you install a non-IDE
hard disk drive and controller card, you need to disable
the built-in IDE hard disk drive interface by moving
jumper J35 to position 2-3. If you disable the on-board
IDE, you will not be able to benefit from the built-in local
bus IDE controller.
If you plan to install two hard disk drives in the internal
bays, you must use flat-head screws (#6-32UNC x 8
FH,M,+) to secure the top drive to the mounting bracket.
12/93