diLUSSO OV607SSL 설치 및 운영 매뉴얼 - 페이지 5
{카테고리_이름} diLUSSO OV607SSL에 대한 설치 및 운영 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. diLUSSO OV607SSL 14 페이지.
페이지 인쇄
The sides and the face surface where the oven is to be installed should be milled to allow sufficient air
intake and circulation around the oven, to avoid causing any damage to the furniture.
Ensure the oven in secured firmly in place as described above, and insulate electrical connections in order to
avoid contact with metallic parts. Any protective parts must be secured so that they can only be removed
with the use of tools. The adhesive joining the rolled sections to the cabinet has to withstand temperatures
no lower than 120 C to avoid deformations or instability.
For the most efficient air circulation, the oven should be fitted according to the dimensions shown. The rear
panel of the cabinet must be removed so that air can circulate freely. The panel to which the oven is fitted
should have a gap of at least 70 mm at the rear.
Do not switch on the appliance before it has been fully and correctly installed.
Before using the oven, we suggest to:
Remove the special film covering the oven door glass (if there is any)
Heat the empty oven at max. temperature for 45 minutes. This is to remove any unpleasant smell caused by
working residues.
Carefully clean the internal cavity of the oven with soapy water and rinse it.
IMPORTANT!
When the oven is in operation, hot surfaces might occur at the oven door. Take note of the "Warning! Hot
Surface" sign. Make sure children do not go near the oven when it is in use.
Version 1.1
Page 4
Dec 2016