Epson Apex 제품 지원 게시판 - 페이지 42

{카테고리_이름} Epson Apex에 대한 제품 지원 게시판을 온라인으로 검색하거나 PDF를 다운로드하세요. Epson Apex 45 페이지. Product support bulletin(s)
Epson Apex에 대해서도 마찬가지입니다: 제품 정보 매뉴얼 (3 페이지), 제품 지원 게시판 (29 페이지), 제품 지원 게시판 (21 페이지)

Epson Apex 제품 지원 게시판
NUMBER:
S-0001C
PANASONIC
JU-595-10
COMMENT
CODE
EXPLANATIONS:
A. Requires insulating sheet when installed in lower position in
Equity
See TIB Equity 11-006.
II.
B. Jumper block
C. Equity
must have ROM BIOS version 2.21(MSA-B4) and MS-DOS 2.11
I
Release 1.04 or higher to use this drive.
D. Must set drive select jumpers on FDD logic board for A
(position S1) or B (position S2).
E.
is
not
necessary
It
F. Handle drive with care - possibility of short circuit between
screw head on frame and FDD logic board (could damage FDD)!
G. Terminator must be removed when used as 2nd floppy drive unit.
H.
See
Product
Same
as
MD-5201-57
I.
Jumper
block
J.
- Position DS0 for drive A, DS1 for drive B
SS1
to
remove
Support
Bulletin
except
comes
- Position S1 for drive A, S2 for drive B.
JJ1
the
terminating
S-0020
for
set-up
configured
as
PAGE:
2 of 5
resistor
pack.
information.
2nd
drive.