Epson Apex 200 제품 지원 게시판 - 페이지 10
{카테고리_이름} Epson Apex 200에 대한 제품 지원 게시판을 온라인으로 검색하거나 PDF를 다운로드하세요. Epson Apex 200 12 페이지. Product support bulletin(s)
Epson Apex 200에 대해서도 마찬가지입니다: 제품 지원 게시판 (45 페이지)
페이지 인쇄
Q. Will the APEX 200 work in foreign countries?
A. The APEX 200 computer can be used in both the United States and
internationally simply by selecting the appropriate input voltage on the
voltage selection switch located on the rear of the unit. The APEX 200 will
operate on either 115VAC or 230VAC at 50/60 Hz power.
Most monitors and printers are not designed to operate on dual voltages
and will be damaged if plugged into the wrong AC voltage. This applies to
the Apex monitors and printers as well. You should use a heavy duty step
down transformer to convert 230VAC to 115VAC for these types of
products.
Q. What streamer tape drives can be used for high speed backup?
A. The APEX 200 has been tested with the following file backup units:
Backup Diskit - 60MB, Model TEX- 60 (Idea Associates)
Everex Stream - 20MB, Model 4.02 (Everex Systems, Inc.)
Mountain Series 4000 Filesafe (Mountain Computer, Inc.)
Tecmar QT - 60e (Tecmar Inc.)
Tallgrass TG - 4060 +
Q. Are there any extension cables available for the APEX 200 enhanced
keyboard?
A. Epson does not provide extension cables due to FCC restrictions. Third
patty extension cables will work although they will not have a 90 degree
angle connector.
Q. What are the CPU wait states for the APEX 200?
A. The default wait state for the APEX 200 I/O bus is 1, adjustable to 4, 3,
or 2 by setting jumpers J2 and J3 on the ANDRO board according to the
User's Guide. The system memory, (RAM and ROM) defaults to one wait
state adjustable to two by setting jumper J1 to B on the ANDRO board.
(Tallgrass Technologies Corp.)
PSB No: S-0098
Page:
7 of 8