Motorola CB300-D 사용자 설명서 - 페이지 37

{카테고리_이름} Motorola CB300-D에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Motorola CB300-D 42 페이지.

CHANNEL READY DELAY

The Motorola digital radio system will not broadcast while the radio channel is in use by others,

or if a mating digital receiver is not found (with an identical Channel No and Profile ID). The DLR

modem module will provide a "ready to transmit" signal if a mating digital radio is found, and if

the channel is not busy. To conserve battery power, the RF Module is powered down until needed

for a radio broadcast. After RF Module power-up, the system will verify the radio channel is clear

and a mating digital radio is available before message broadcast will occur. If a mating receiver

is not detected or a busy channel is detected, the system will attempt re-connection based Chan

Ready Delay value (configured using the LCD menu, "Chan Ready Delay? shown below).

Chan Ready Dly?

Old = 20 Sec

New = 20 Sec

In the example above, the Channel Ready Delay is set = 20 Seconds. If the Channel Ready signal

is not received, the system will re-try for a "Ready" channel every 4-seconds until a "Ready"

channel is detected, or until the 20-second Channel Ready Delay timer expires.

Press the

button until the Chan

Ready Dly? menu is shown. Press the

button to begin the next step.

Use the

buttons to cycle through the

Chan Ready Delay selections (8-120 seconds).

ENTER

Press

to select the new value, or

to exit without any changes. Default is

20-seconds.

ENTER