Motorola CLP series 사용자 설명서 - 페이지 32

{카테고리_이름} Motorola CLP series에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Motorola CLP series 48 페이지. By wsi
Motorola CLP series에 대해서도 마찬가지입니다: 빠른 참조 매뉴얼 (2 페이지), 빠른 참조 (2 페이지), 빠른 참조 (35 페이지), 문제 해결 매뉴얼 (2 페이지)

페이지 인쇄

68012000044-ED

Chapter 5 : Radio Cloning

2 Plug one side of the cloning cable micro USB to one SUC and plug the other end to the second

SUC.

NOTE:

During the cloning process, no power is applied to the SUC. The batteries cannot be

charged. A data communication is established between the two radios.

3 Turn on the target radio and place it into one of the SUC.

4 To power the source radio, press and hold the PTT button and the - button simultaneously while

turning on the radio until you hear the cloning tone and the yellow LED double blinks on the

smart status glow.

5 To start the cloning process, place the source radio in its SUC with an audio accessory, then

press and release the Menu button.

If successful, the source radio sounds a good key chirp tone.

If unsuccessful, the source radio sounds bonk tone.

The tone sounds for no more than five seconds.

6 Turn the radios off and on to bring the radios to the user mode by exiting the clone mode when

the cloning process is completed.

5.3

Cloning Radios using the Multi-Unit Charger

Prerequisites: Cloning radios using Multi-Unit Charger (MUC) Kit part number HKPN4007_ (optional

accessory)

Procedure:

1 To put the source radio into clone mode, press and hold the source radio PTT button and the -

button simultaneously while turning on the radio until you hear the cloning tone and the yellow

LED double blinks on the smart status glow ring.

2 Place the source radio into one of the charging pockets that has the CLONE label.

3 Turn on the target radio and place it in the pairing charging pocket that has the CLONE label

and start the cloning process.

4 To start the cloning process, press the Menu button on the source radio.

The source radio generates the start clone tone.

5 To activate the radio, turn off and on the radios when cloning process is completed.

6 To clone another radio, repeat

7 To exit clone mode on the source radio, turn off the radio.

step 3

step