Epson EISA Tower 제품 정보 매뉴얼 - 페이지 6

{카테고리_이름} Epson EISA Tower에 대한 제품 정보 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Epson EISA Tower 9 페이지. Tower

EISA Series Tower

Hard Disk Drives

The following table lists the types of hard disk drives you can use in
your computer. Check this table and the manual that came with your
hard disk to find the correct type for the hard disk drive(s) installed
in your computer. Then select that type at the hard disk drive Type
prompt. If you do not find your drive type in the table, select User
defined and enter your drive's parameters.
Hard disk drive types
Tower-6
(1) Miniscribe 8425F, Seagate ST125
(2) for Seagate (formerly CDC Imprimis) default setting (34 sectors per track)
(3) Micropolis 1325. Atasi 3085. Lanstor Lan64 Maxtor XT1085, Newbury NDR1085
(4) Micropolis 1323A Miniscribe 3035, Microscience HH1050. Seagate ST4053
(5) Epson IDE drives: 40MB (type 59), 100MB (type 60). 200MB (type 64)
(6) The BIOS translates the actual parameters for Cylinders. Heads, and Landing zone to these
values. The parameters listed in your drive's documentation may be the following:
Cylinders (1366), Heads (8), and Landing zone (1355).
Hard disk drive jumper settings
Jumper
One Hard Disk Two Hard disk
drive
HSP
C/D
X
-
DSP
A C T
X
X = jumper installed
- = no jumper installed
Note: If you install two 200MB hard disk drives, install one jumper
from each drive in the two jumper positions on the master drive. Do
not instaIl any jumpers on the slave drive.
The folIowing illustration shows the location of the jumpers on the
optimal Epson 200MB IDE hard disk drive.
1/92
Two hard disk
drives: slave
(primary)
X
X
X
EISA Series Computers