Motorola GP240 사용자 설명서 - 페이지 41

{카테고리_이름} Motorola GP240에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Motorola GP240 46 페이지. Professional radio, power distribution and controller
Motorola GP240에 대해서도 마찬가지입니다: 서비스 정보 (32 페이지), 서비스 정보 (30 페이지), 사용자 설명서 (46 페이지), 서비스 정보 (30 페이지)

페이지 인쇄

CONVENTIONAL FEATURES

This section outlines the conventional features of your

radio. All references to what is shown on the display is

only valid for GP280 radios. Throughout this section,

the display below

PLANT POLICE

is used to indicate the radio's home display.

REPEAT/DIRECT

The repeat/direct feature allows you to bypass the

repeater and talk directly to another portable radio.

This is known as DIRECT operation. The transmit

frequency is the same as the receive frequency.

•

In REPEAT operation, you talk through the

repeater, which increases the radio's operating

range. The transmit frequency is not the same

as the receive frequency.

•

If the repeat/direct feature is programmed to a

mode, that mode operates on either direct or

repeat operation.

•

If the repeat/direct feature is programmed to the

keypad, you can change the repeat/direct setting

by doing the following.

1. Press / until DIR is

displayed.

2. Press l (the softkey below DIR).

3. The current talkaround

4. Then, the display

5. Press l below the desired talkaround

6. The radio returns to the

SMART PTT

Smart PTT is a per-mode feature which gives the

system manager better control of radio operators.

When smart PTT is enabled in your radio, you cannot

transmit on an active mode. Three radio-wide

variations of smart PTT are available.

•

PWR

PROG

DIR

state appears on the

display for a few

seconds.

prompts for the new

state.

state: repeat (RPTR) or direct (DIR).

home display.

Transmit Inhibit on Busy Mode—you are

prevented from transmitting if any activity is

detected on the mode.

REPEATER MODE

DIRECT MODE

DIR

RPTR

PLANT POLICE

English