Motorola GP360 Series 서비스 정보 - 페이지 19
{카테고리_이름} Motorola GP360 Series에 대한 서비스 정보을 온라인으로 검색하거나 PDF를 다운로드하세요. Motorola GP360 Series 32 페이지. Professional radio, power distribution and controller
Motorola GP360 Series에 대해서도 마찬가지입니다: 사양 시트 (2 페이지), 기본 사용 설명서 (18 페이지), 운영 지침 (4 페이지), 서비스 정보 (30 페이지), 서비스 정보 (30 페이지)
페이지 인쇄
Frequency Generation Circuit
Tx
Rx
Battery Saver
In the receive mode, U241 pin 19 is low or grounded. This activates the receive VCO by enabling the
receive oscillator and the receive buffer of U241. The RF signal at U241 pin 8 is run through a
matching network. The resulting LO RF INJECTION signal is applied to the mixer at T302.
During the transmit condition, when PTT is pressed, five volts is applied to U241 pin 19. This
activates the transmit VCO by enabling the transmit oscillator and the transmit buffer of U241. The
RF signal at U241 pin 10 is injected into the input of the PA module (U101 pin16). This RF signal is
the TX RF INJECTION. Also in transmit mode, the audio signal to be frequency modulated onto the
carrier is received through U201, pin 41.
When a high impedance is applied to U241 pin19, the VCO is operating in BATTERY SAVER mode.
In this case, both the receive and transmit oscillators as well as the receive transmit and prescaler
buffer are turned off.
Table 2-1 Level Shifter Logic
Desired
AUX 4
Mode
Low
High
Low
AUX 3
High (@3.2V)
High (@4.8V)
Low
Low
Low
Hi-Z/Float (@2.5V)
TRB
2-9