Motorola HMN9038 - HMN 9038 - Headset 소유자 매뉴얼 - 페이지 8
{카테고리_이름} Motorola HMN9038 - HMN 9038 - Headset에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Motorola HMN9038 - HMN 9038 - Headset 24 페이지. Professional two-way radio
GETTING STARTED
Batteries
The Ni-Cad battery ships uncharged, it must
be fully charged for 16 hours before use (first
charge only). It is recommended that only
Motorola batteries and chargers are used
with the radio.
The Ni-Cad rechargeable battery pack will
provide approximately 8 hours of operation
for your radio with normal use (5% sending
messages, 5% receiving messages and 90%
in standby mode).
Low Battery Alert
When the battery is low, the radio will beep:
• 3 to 4 seconds after turning power on
• Every 10 minutes in standby mode
• After release of the Push-To-Talk button
Recharge the battery pack immediately to
avoid interrupted use.
Note: Remove battery pack before storing
your radio for extended periods. Batteries
may corrode over time if left in radio and can
cause permanent damage to your radio.
FIG. D
6
To Install/Remove Batteries
Note: Radio must be OFF before installing/
removing battery.
1. Push back both battery cover latches until
you see the orange tabs.
2. Slide battery cover down and lift to remove.
Fig. D
To replace/install battery, insert the battery
pack with arrows pointing towards the top of
the radio. Fig. E
3. Replace battery cover and lock latches.
4. To remove battery, remove cover, turn the
radio over and tap the battery end of the
radio against the palm of your hand. The
battery will drop into your hand. Fig. F
Note: Do not remove the plastic wrap from
the battery pack. This will permanently dam-
age the battery.
FIG. E
FIG. F