Motorola MD207 Series 매뉴얼 - 페이지 14
{카테고리_이름} Motorola MD207 Series에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Motorola MD207 Series 16 페이지.
Motorola MD207 Series에 대해서도 마찬가지입니다: 사용자 설명서 (2 페이지)
페이지 인쇄
and you can hear the transmission. Any Interference Eliminator Code that may be in use
by that party will be detected and displayed.
4. To respond and talk to the person transmitting, press
within five seconds of the
end of the transmission. The radio will transmit using the newly detected Interference
Eliminator Code.
5. The radio will resume scrolling through the channels five seconds after the end of any
received activity.
6. To stop scanning, briefly press the
key.
Scanning Notes:
1. If you press while the radio is scrolling through inactive channels, the transmission will
be on the "home channel". Scanning will resume five seconds after the end of your
transmission. You may press the key to stop scanning at any time.
2. If the radio stops on an undesired transmission, you may immediately resume the scan
by briefly pressing
or
.
3. If the radio repeatedly stops on an undesired transmission, you may temporarily
remove that channel from the scan list by pressing and holding
or
for three
seconds. You may remove more than one channel in this way.
4. To restore the removed channel(s) to the scan list, turn the radio off and then back on,
or exit and re-enter the scanning mode by pressing
.
5. You cannot remove the home channel from the scan list.
6. In Advanced Scan, the detected code will only be used for one transmission. You must
note the code, exit scan, and set that detected code on that channel to permanently use
the detected code.
Use With Accessories
You can transmit more reliably with the use of optional PTT headset accessories. A PTT
headset allows privacy to others around you while listening.
Many accessories (sold separately) are available for your radio. For more information,
visit our Web site at www.motorolasolutions.com or shop.giantintl.com.
1. Turn the radio off and plug the PTT accessory into the accessory jack.
2. Turn the radio on. You may now press the PTT on the accessory microphone instead of
the radio.
3. Adjust the volume appropriately by pressing
. Lower the volume before placing
the accessory on your head or in your ear.
Note: The MD Series does not have VOX capabilities, and is only compatible with PTT
headset accessories.