Epson Equity 386SX PLUS 제품 정보 매뉴얼 - 페이지 5
{카테고리_이름} Epson Equity 386SX PLUS에 대한 제품 정보 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Epson Equity 386SX PLUS 10 페이지. Product support bulletin(s)
Epson Equity 386SX PLUS에 대해서도 마찬가지입니다: 제품 지원 게시판 (19 페이지), 제품 정보 매뉴얼 (10 페이지), 제품 지원 게시판 (26 페이지), 제품 지원 게시판 (45 페이지)
페이지 인쇄
Installation/Support Tips
Power
The Equity 888SK haa a power supply that is switchable
between 118V, for USA and Canadian use, and 28OV, for
the rear of the CPU between the AC inlet and the AC
outlet. (see figure below)
the AC inlet and the AC outlet. If the CPU is
peripherals oertifled for use at 28OV should be
plugged into the outlet.
CPU SPEEO
Installing Floppy Disk Drives
When installing a floppy disk drive as drive 8,
remember to set the drive select jumper to the
second position and attach the pas&through
Equity Series Computers
not changed between
hard disk w
connector on the Rope drive oontroller cable
If the drive doe6 not funcbon normally, make
been installed correctly.
Installing Hard Disk Drives
It is recommended that
disk controller be used in the Equity 888SX, lf
a
you are installing
of the internal hard disk oontrollr. Also
remember to disable the onboard hard disk
controller when in8talling such
setup
When installing an optional expanded memory
board, do not list the memory under the
memory expansion optfon in SETUP. That
option is for EXTENDED memory ONLY.
a hard
Adding Memory Modules
The total amount of memory must be one of
the following: 1 MB, 2MB, 4MB, 8MB, 8MB,
Memory banks must be filled with one size
SIMM. You cannot mix SIMM types in one
bank.
only 1 MB SIMM% The 288KB SIMM sockets
must be filled before using any of the 1 MB
sockets.
Software Problems
When installing a copy-protected software
package on the Equity 888% first try the
EQUITY 386SX
a
a
disk drive, be sure to
EQ386SX-5