Epson Equity 386SX PLUS 제품 지원 게시판 - 페이지 21

{카테고리_이름} Epson Equity 386SX PLUS에 대한 제품 지원 게시판을 온라인으로 검색하거나 PDF를 다운로드하세요. Epson Equity 386SX PLUS 26 페이지. Product support bulletin(s)
Epson Equity 386SX PLUS에 대해서도 마찬가지입니다: 제품 지원 게시판 (19 페이지), 제품 정보 매뉴얼 (10 페이지), 제품 정보 매뉴얼 (10 페이지), 제품 지원 게시판 (45 페이지)

Epson Equity 386SX PLUS 제품 지원 게시판
EPSON
EPSON AMERICA, INC.
Subject:
Equity 386SX Plus HDD Interface Cable
Date: 12/5/90
Page(s): 1 of 2
The purpose of this bulletin is to provide information on installing the hard disk
interface cable, if and when an IDE hard disk is installed.
This procedure is not for systems that came with a hard disk drive already installed.
The cable will come packaged in the computers shipping container.
Lay the cable out with the circuit board connector to the left and line
1:
along the bottom.
Fold the cable down about 3.75" from the right, along the top of the cable,
2:
making a 90 degree angle at that point. Press down firmly to crease the cable.
Fold the cable in half at the center connector, so the circuit board connector is
3:
now on the right.
Fold the cable back to the left making a straight crease that aligns along the right
4:
edge of the first fold. The cable is now lying over the center connector.
With that same part of the cable, fold the cable at a 90 degree angle at the right
5:
edge of the previous fold so the circuit board connector is facing down and the
cable is lying over the other connector. Crease the fold.
Take the center connector, now on the left side, and make a fold about 2" in from
6:
the center connector. Fold it down, making a 90 degree angle. Crease the fold.
INFORMATION
Product Support Bulletin
FOLDING THE INTERFACE CABLE
PSB No:
S-0127
Originator: DS
1 (RED)