페이지 인쇄Model J06
Installation Manual
❖Accessories
Description of good
Bracket for machine
Electrical cable
Emergency cable
Air hose
Air regulator
Bolts
①for the bracket
②for the machine
③pass line adjusting
Fixture for the air regulator
④Bonding
Mark tube, Terminal
Sticker
Signal(Feed/Release), Scale for
pass line(on the bracket)
Air connector
⑤Apron plate
❖Method of Input
①
Power
②
Set ⇔ Run
Numeric value that can be changed item or number will be blink.
③
← →
④
+/-
If you need to continue inputting, repeat the ③, ④.
After setting
⑤
Set ⇔ Run
⑥
Sync
Feed
Usually, the Release mode does not display.
Only when changing settings item, the Release mode is supposed to display on the
"Feed Length" after displaying digit of lowest of "Feed Length"
J06
Exclusive type
P6：8M
8M
8*5：6M
With air filter
2-M12*30
4-M8*15
1-M12*120
2-M6*12
Net 4ml
Assortment
1-TS8-03, 2-NTS8-02
Exclusive type
Turn on "Power" switch
You can input a set value when "Set" lamp is lit.
Using the switches, you can move the cursor position.
Using the switches, you can change the value.
Push "Set ⇔ Run" switch, when "Run" lamp is lit, the setting
finishes.
Sync
Release
1
DIMAC
②
③
Press the both switches of Sync Feed and
Sync Release switches, then the controller will
be able to receive the sync press cam signals.
⑤
④
①