Motorola XU2100 - XTN Series UHF 사용자 설명서 - 페이지 17
{카테고리_이름} Motorola XU2100 - XTN Series UHF에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Motorola XU2100 - XTN Series UHF 35 페이지. Xtn series
Motorola XU2100 - XTN Series UHF에 대해서도 마찬가지입니다: 사용자 설명서 (15 페이지)
페이지 인쇄
Programming Features
You can change the following features by entering the programming mode (k).
To talk with someone on your two-way radios, these settings must match:
•
Channel (XU2600 and XV2600 only)
•
Frequency
•
Interference Eliminator Code
•
Scramble code
•
Bandwidth (for optimal clarity)
You can also use k to set the following:
•
Call tones
•
Microphone Gain
•
Scan List (XU2600 and XV2600 only)
•
Available channels (XU2600 and XV2600 only)
Note: You cannot enter kwhile a VOX accessory is plugged into the radio.
Entering Programming Mode
You must enter Programming Mode to change your communication settings.
1. Press and hold MJ for three seconds while turning on your
radio. The radio beeps and displays k.
Programming a Channel (XU2600 and XV2600 only)
Each channel has its own Frequency, Interference Eliminator Code, Scramble Code,
and Bandwidth Settings.
Program each channel separately.
1. Select the channel that you will be programming.
2. The channel number flashes. l and code displays
alternately.
3. Press [ or ] to select the desired channel.
4. Press and hold M to exit k, or press \ to continue.
Programming the Frequency
Sets the frequency that your radio will use. As you are matching your
XTN radio to existing Spirit M-Series radios, enter Programming
Mode as necessary, refer to page 34.
1. Press \to display l. The frequency flashes.
2. Press [ or ] to select the desired frequency (See
"Frequencies and Bandwidths" beginning on page 45).
3. Press and hold M to exit k, or press \ to continue.
X
32
1
X
31
6