Epson Equity Ie 제품 지원 게시판 - 페이지 9
{카테고리_이름} Epson Equity Ie에 대한 제품 지원 게시판을 온라인으로 검색하거나 PDF를 다운로드하세요. Epson Equity Ie 19 페이지. Product support bulletin(s)
Epson Equity Ie에 대해서도 마찬가지입니다: 제품 지원 게시판 (33 페이지), 제품 정보 매뉴얼 (7 페이지), 제품 지원 게시판 (45 페이지), 제품 지원 게시판 (21 페이지)
페이지 인쇄
Q15.
How many internal device bays does the Equity 386SX have and will
it support a full - height device?
A.
The Equity 386SX has 3 half - height bays to support up to 3 half -
height devices. The separator between bays 2 & 3 can be removed
to allow for the installation of a full - height device.
Q16.
How many wait states does the Equity 386SX have?
A.
At 16MHz the system utilizes a "1/4 wait state" architecture for
memory access and 0 wait states for ROM BIOS access on the
motherboard. At 8MHz, memory and ROM BIOS access require 1
wait state; on the expansion bus, all memory or device requests are
1 wait state. If additional wait states are required, devices on the
I/O channel hold the READY signal low thus wait states are
generated until the device can respond to the CPU.
Q17.
Are the wait states user selectable?
A.
No, the Equity 386SX automatically inserts them when needed after
the command phase of the processor clock cycle.
Q18.
How many jumpers are on the system board?
A.
There are five (5) jumpers on the system board:
System Board:
Jumper 1: Co - Processor Installed/Not Installed
Jumper 2: Password
1 - 2: Installed
2- 3: Not Installed (Factory Setting)
1 - 2: Password Enabled (Default)
2 - 3: Password Disabled
PSB No: S-0106
Page 4 of 8