Motorola MBP31 Triple 사용자 설명서 - 페이지 18

{카테고리_이름} Motorola MBP31 Triple에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Motorola MBP31 Triple 32 페이지.

7. Help

Display

No display

• Try recharging or replacing the battery pack.

• Reset the units. Disconnect the battery pack of the parent unit and

unplug both the units' electrical power, then plug them back in.

• Is the unit turned on?

Press and release

• Is the correct camera channel number selected?

Change the camera channel number, if necessary.

Registration

If the Camera unit has lost its link with the parent unit

• Try recharging or replacing the battery pack.

• If the Camera unit is too far away it may be going out of range, so

move the Camera unit closer to the parent unit.

• Reset both units by unplugging their batteries and mains electrical

power. Wait for 15 seconds before reconnecting them. Allow up to

one minute for the Camera unit and the parent unit to synchronise.

• See section "2.4 Registration" if there is a need to re-register the units.

Interference

Noise interference on your parent unit

• Your camera and parent units may be too close. Move them further

away from each other.

• Make sure there is at least 1 metre between the 2 units to avoid

audio feedback.

• If the Camera unit is too far away it may be going out of range, so

move the Camera unit closer to the parent unit.

• Make sure the camera and parent units are not near other electrical

equipment, such as a television, computer or cordless/mobile telephone.

on the parent unit to turn it on.

Help