Motorola MBP36P/3 사용자 설명서 - 페이지 9

{카테고리_이름} Motorola MBP36P/3에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Motorola MBP36P/3 28 페이지. Digital baby monitor
Motorola MBP36P/3에 대해서도 마찬가지입니다: 빠른 시작 매뉴얼 (2 페이지)

페이지 인쇄

2.3

Parent Unit Power Supply

IMPORTANT

Installing the rechargeable battery pack and charging it fully before use is

recommended. This will allow the unit to operate on battery in the event

of a power failure.

1. Connect the small plug of the power adapter to the parent unit and

the other end to the electrical outlet. Only use the enclosed power

adapter (6V DC/500mA).

2. Press and hold the

bar finishes scrolling, to turn ON the parent unit.

3. Once the baby and parent units are switched on, the display on the

parent unit will show the video captured by the baby unit.

4. If there is no connection or you are out of range, the video display

will go off and the words

and the unit will beep every 5 seconds. Move the parent unit closer

to the baby unit until the link is re-established.

5. Press and hold the

bar finishes scrolling, to turn OFF the parent unit.

NOTE

The battery icon

LED blinks, and it gives a beep every 16 seconds. The battery needs to

be recharged. The battery pack takes about 16 hours to charge fully.

When charging

1. During power OFF, when the adapter is plugged in, a flashing battery

symbol will display for 45 sec. The Blue LED at the top left will flash to

indicate the adaptor is plugged in.

Getting Started

POWER ON/OFF button, until the progress

No Signal

will be shown on the LCD display,

POWER ON/OFF button, until the progress

turns RED to indicate that the battery is low, the red