Motorola MBP432 사용자 설명서 - 페이지 9

{카테고리_이름} Motorola MBP432에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Motorola MBP432 27 페이지. Digital video baby monitor
Motorola MBP432에 대해서도 마찬가지입니다: 빠른 시작 매뉴얼 (2 페이지), 사용자 설명서 (27 페이지), 사용자 설명서 (29 페이지)

페이지 인쇄

2.3

Parent Unit Power Supply

IMPORTANT

Installing the rechargeable battery pack and charging it fully before use is

recommended. This will allow the unit to operate on battery in the event

of a power failure.

1. Connect the small plug of the power adapter to the parent unit and

the other end to the electrical outlet. Only use the enclosed power

adapter (6V DC/500mA).

2. Press and hold the

turn ON the parent unit.

3. Once the baby and parent units are switched on, the display on the

parent unit will show the video captured by the baby unit.

4. If there is no connection or you are out of range, the video display

will go off and the words

and the unit will beep every 5 seconds. Move the parent unit closer

to the baby unit until the link is re-established.

5. Press and hold the

bar finishes scrolling, to turn OFF the parent unit.

NOTE

The battery icon

gives a beep every 16 seconds. The battery needs to be recharged. The

battery pack takes about 16 hours to charge fully.

When charging

If the parent unit is turned OFF, when the adapter is plugged in, a mains

plug logo will display

segments cycling for 45 seconds. The Blue LED in the top left corner

lights up to indicate the adapter is plugged in.

Getting Started

POWER ON/OFF button for 1 second to

No Signal

POWER ON/OFF button, until the progress

turns RED to indicate that the battery is low, and it

briefly, followed by a large battery icon with internal

will be shown on the LCD display,