Motorola MBP433 사용자 설명서 - 페이지 10

{카테고리_이름} Motorola MBP433에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Motorola MBP433 29 페이지. Digital video baby monitor
Motorola MBP433에 대해서도 마찬가지입니다: 사용자 설명서 (27 페이지), 빠른 시작 매뉴얼 (2 페이지), 사용자 설명서 (27 페이지)

페이지 인쇄

2.3

Parent Unit Power Supply

IMPORTANT

Installing the rechargeable battery pack and charging it fully before use is

recommended. This will allow the unit to operate on battery in the event of a

power failure.

1. Connect the small plug of the power adapter to the parent unit and the

other end to the electrical outlet. Only use the enclosed power adapter (6V

DC/500mA).

2. Press and hold the

the parent unit.

3. Once the baby and parent units are switched on, the display on the parent

unit will show the video captured by the baby unit.

4. If there is no connection or you are out of range, the video display will go

off and the icon

every 5 seconds. Move the parent unit closer to the baby unit until the link is

re-established.

5. Press and hold the

finishes scrolling, to turn OFF the parent unit.

NOTE

The battery icon

to be recharged. The battery pack takes about 16 hours to charge fully.

When charging

1. If the parent unit is turned OFF, when the adapter is plugged in, a mains

plug logo will display briefly, followed by a large battery icon with internal

segments cycling for 45 seconds. The Blue LED in the top left corner lights

up to indicate the adapter is plugged in.

POWER ON/OFF button for 1 second to turn ON

will be shown on the LCD display, and the unit will beep

POWER ON/OFF button, until the progress bar

turns RED to indicate that the battery is low, and it needs

Getting Started