ARGtek CPE2512 매뉴얼 - 페이지 2

{카테고리_이름} ARGtek CPE2512에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. ARGtek CPE2512 3 페이지.

3. PoE connection

1. Connect (POE) RJ45 Jack to CPE RJ45 Jack with good quality

Ethernet cable.

2. Connect (LAN) Jack to PC or Switch Hub LAN port.

3. Plug in the power adaptor to PoE DC jack.

4. CPE Connection

1. Open the CPE enclosure you will find two RJ45 Jacks two LEDs and

one reset button.

2. Connect the PoE cable to either LAN or WAN port.

3. To reset the CPE just press and hold the reset button for about 10

seconds and wait for 55 seconds to reboot the CPE.

Notice:

This CPE default operation mode is in Bridge mode. Both LAN and WAN

ports are in the same switch hub. Please go to the webpage and change

the operation mode to Gateway mode when you are going to use the

WAN port for your CPE.