Motorola B803 사용자 설명서 - 페이지 30

{카테고리_이름} Motorola B803에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Motorola B803 47 페이지. Dect 6.0 cordless answering system with bluetooth wireless technology
Motorola B803에 대해서도 마찬가지입니다: 빠른 시작 매뉴얼 (8 페이지)

페이지 인쇄

REGISTRATION

Your new telephone system can accommodate up to 6 handsets. You can add new handsets to

your telephone system, but each device must be registered with the telephone base before use.

7.1

Handsets purchased separately need to be registered to the telephone base before use. When

first purchased, all expansion handsets will show NOT REGISTERED on the screen. The new

handset(s) may need to be charged for five minutes before registering to the telephone base.

1. Place the unregistered handset into the telephone base. If PRESS FIND FOR 4 SEC ON

BASE does not appear on the handset screen after a few seconds, remove the handset and

place it in the telephone base again.

2. On the telephone base, press and hold FIND for about four seconds (until the red IN USE light

on the telephone base turns on) and then release the button. The handset will show PLEASE

WAIT... and it will take about 10 seconds to complete the registration. The handset will display

HANDSET X REGISTERED, with X denotes the handset number (1-6). There will be a beep

sound if the registration is successful.

NOTES

1. If the registration is not successful, the display will show NOT REGISTERED. To reset the

handset, remove the handset from the telephone base and place it back in. Try the registration

process again.

2. You cannot register a handset if any other system handset is in use.

7.2

De-register all handsets

You may need to de-register your handsets if:

You have six registered handsets and need to replace a unit.

You wish to change the designated handset number of your registered handsets.

You must first de-register ALL the handsets, and then re-register each handset you wish to use.

Please read carefully through all the instructions on this page before beginning the de-registration

process.

1. Press and hold FIND on the telephone base for about 10 seconds (until the IN USE light turns

on and starts to flash), then release the FIND button.

2. Immediately press and release FIND again. You must press FIND while the IN USE light is still

flashing. (The light flashes for about seven seconds. If the light stops flashing, pick up the

handset and place it back into the telephone base, then start again with step one above.)

3. The handset(s) will show SEARCHING FOR BASE and it will take about 10 seconds to

complete the de-registration process. ALL handsets will show NOT REGISTERED if de-

registration was successful.

4. To re-register the handset(s) to the telephone base, follow the registration instructions as

section above.

NOTES:

1. If the de-registration process was not successful, you may need to reset the system and try

again. To reset: pick up the handset and press the HOME/FLASH button, then press the

OFF/BACK button and place the handset back into the telephone base. You may also reset by

unplugging the power from the telephone base and plugging it back in.

2. You cannot de-register the handset(s) if any other system handset is in use.