Epson Progression 제품 정보 매뉴얼 - 페이지 5

{카테고리_이름} Epson Progression에 대한 제품 정보 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Epson Progression 8 페이지. Using with ms windows 3.x stylus 400/800+/color printer driver
Epson Progression에 대해서도 마찬가지입니다: 제품 지원 게시판 (15 페이지), 제품 지원 게시판 (17 페이지), 제품 지원 게시판 (3 페이지)

페이지 인쇄

DMA Channels

Hardware Interrupts

CTRL1

CTRL2

Function

Timer Output 0

Keyboard

I/O Port Addresses

Address

Assigned device

DMA controller 1

MO-021

Interrupt controller 1

Timer/counter

060 - 06F

Keyboard controller (8042)

070 - 07F

RTC. NM mask resister

080 - 09F

DMA page registers, MFG port

OAO - OBF

interrupt controller 2 (8259A compatible)

OCO - ODF

DMA controller 2 (8237A-5 compatible)

Clear math coprocessor busy

OF1

Reset math coprocessor

OF8 - OFF

Math ca~rocessor

170 - 178

Hard disk controller secondary

Configuration registers

1 BF'

Configuration register unlock port 1

I/O Port Addresses (continued)

3F0 - 3W

*These I/O address ports are configuration registers.

Jumper Settings

See the Main System Board Map on page 3 for the location of

the jumpers on the main

Main System Board Jumper Settings

Jumper

number

setting

A '

JP3

A '

JP4

JP5

A '

JP6

JP7

A '

JP9

CPU Card Jumpers

Three CPU cards are available for the Progression: 486SX/25,

486DX/33, and 486DX2/66. The jumper on the 486SX/25

card should always be set to position B. The 486DX2/66 card

has no jumpers. Set the jumpers on the 486DX/33 card

according to the table below.

486DX/33 CPU Card Jumpers

CPU card configuration

Card only; no OverDrive module

ODP486DX/33 module installed

10/19/92

EPSON PROGRESSION

board.

system

Function

Diskless mode disabled

Diskless mode enabled

Enables the built-in mouse port

use an external mouse port on an option

Enables an external mouse port on an

option card

disables an external mouse port

Monochrome monitor is installed

Diiies the password function

Enables the password function

Enables the built-in VGA display adapter

Disables the built-in VGA display adapter so

you can use a display adapter on an option

Jumper setting

Epson Progression-5