Motorola D1003 사용자 설명서 - 페이지 7
{카테고리_이름} Motorola D1003에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Motorola D1003 26 페이지. Digital cordless phone
Motorola D1003에 대해서도 마찬가지입니다: 사용자 설명서 (45 페이지), 사용자 설명서 (26 페이지), 사용자 설명서 (50 페이지)
페이지 인쇄
3. Place the handset on the charger to charge for at least 24 hours. When the handset is fully
charged the
icon will indicate that it is fully charged.
4. When the handset is fully charged after 24 hours, plug the telephone line cord from the large
base into the telephone wall socket.
IMPORTANT
Warning! Use only rechargeable batteries. If non-rechargeable batteries are used WARNING BATT will
be displayed and charging will be stopped. Please replace with rechargable batteries.
BATTERY LOW WARNING
If the
icon flashes in the display, you will need to recharge the handset before you can use it
again.
During charging, the
icon will scroll in the display.
BATTERY PERFORMANCE
In ideal conditions, fully charged batteries should give up to 10 hours talk time or up to 150 hours
standby time on a single charge.
Note that new batteries do not reach full capacity until they have been in normal use for several
days.
To keep your batteries in the best condition, leave the handset off the base for a few hours at a
time.
Running the batteries right down at least once a week will help them last as long as possible.
The charge capacity of rechargeable batteries will reduce with time as they wear out, giving the
handset less talk/standby time. Eventually they will need to be replaced.
After charging your handset for the first time, subsequent charging time is about 6–8 hours a day.
Batteries and handset may become warm during charging. This is normal.
Getting started
Setting up your D1000
Date and time
Providing you have subscribed to your network's Caller ID service, the date and time is set
automatically for all handsets every time a call is received.
If you do not have a Caller ID service you can set the date and time manually.
Set date and time manually
m
d
1. Press
and scroll
to CLOCK/ALARM. Press
m
.
2. Enter the date using the format
DD/MM
e.g.
m
3. Press
and enter the time using the 24 hour format HH:MM,
e.g. 14:45 for 2:45pm.
m
>
4. Press
to confirm or
to return to standby.
Your D1000 is now ready for use.
m
. Display shows
DATE &
TIME, then press
04/ 08
for 4th August.
7