Motorola D1004 사용자 설명서 - 페이지 34
{카테고리_이름} Motorola D1004에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Motorola D1004 50 페이지. Digital cordless phone
Motorola D1004에 대해서도 마찬가지입니다: 사용자 설명서 (45 페이지), 사용자 설명서 (26 페이지), 사용자 설명서 (26 페이지)
페이지 인쇄
5. Enter the number. Press
>
6. Press
to return to standby.
NOTE
If you switch Easy call on,
You can not set Easy call
8.4.3
Dial an Easy call number
When an Easy call number has been stored and the Easy call setting switched ON, press
>
any key (apart from
NOTE
When Easy call is switched ON, you can still answer any incoming call as normal.
8.5
Registration
Up to 5 handsets can be registered to one base station. Additional handsets must be
registered to the base before you can use them.
•
The instructions described below apply specifically to your D10 handset. If you wish to
register another manufacturer's handset, the instructions may vary. In this case, please
refer to the manufacturer of the additional handset.
•
The Master PIN is required before you can register or unregister handsets. The default
PIN is 0000.
8.6
Register a handset
At the base:
1. Press and hold the
seconds in which to register a handset.
At the handset:
m
1. Press
and scroll
d
2. Scroll
to
REGISTRATION
u
d
3. Scroll
or
to display
the registered base number is flashing. Enter the number of the base on which you
wish to register your handset.
If you have only 1 base station, press
2
, etc.
4. When the display shows
When the handset registers with the base, it is assigned a handset number.
8.7
Select a base
You can register your D10 handset with up to 4 bases. Once registered, you can switch
between bases, for example, bases at home and at work.
m
1. Press
and scroll
34
m
to confirm.
EASY CALL
will be displayed on your screen in standby mode.
ON
until an Easy call number has been stored.
), to dial a number.
p
button on the base station for at least 3 seconds. You have 90
d
to
ADVANCED SET
m
and press
REGIST. BASE
and press
1
PIN
?, enter the base PIN and press
d
to
ADVANCED SET
m
and press
.
m
.
BASE 1 2 3 4
. If you have 2 base stations, press
m
m
and press
.
is displayed and
1
or
.
.
Advanced settings