Motorola D1011 사용자 설명서 - 페이지 7
{카테고리_이름} Motorola D1011에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Motorola D1011 35 페이지. Motorola d1010 series digital cordless phone with answer machine
Motorola D1011에 대해서도 마찬가지입니다: 사용자 설명서 (30 페이지)
페이지 인쇄2. Insert the 2 x AAA NiMH batteries supplied into the handset. Then
slide the compartment cover into place.
3. Place the handset on the charger to charge for at least 24 hours.
When the handset is fully charged the
fully charged.
4. When the handset is fully charged after 24 hours, plug the telephone
line cord from the large base into the telephone wall socket.
IMPORTANT
Warning! Use only rechargeable batteries. If non-rechargeable batteries
WARNING BATT
are used
will be displayed and charging will be stopped.
Please replace with rechargable batteries.
BATTERY LOW WARNING
If the
icon flashes in the display, you will need to recharge the handset
before you can use it again.
During charging, the
icon will scroll in the display.
BATTERY PERFORMANCE
In ideal conditions, fully charged batteries should give about 10 hours talk
time or 100 hours standby time on a single charge.
Note that new batteries do not reach full capacity until they have been in
normal use for several days.
To keep your batteries in the best condition, leave the handset off the
base for a few hours at a time.
Running the batteries right down at least once a week will help them last
as long as possible.
The charge capacity of rechargeable batteries will reduce with time as
they wear out, giving the handset less talk/standby time. Eventually they
will need to be replaced.
After charging your handset for the first time, subsequent charging time
is about 6–8 hours a day. Batteries and handset may become warm
during charging. This is normal.
Getting started
Date and time
Providing you have subscribed to your network's Caller Display service,
the date and time is set automatically for all handsets every time a call is
icon will indicate that it is
received.
The date and time is recorded with each answer machine message you
receive.
If you do not have a Caller Display service you can set the date and time
manually.
Set date and time manually
1. Press
2. Enter the date using the format
3. Press
4. Press
Your D1011 is now ready for use.
m
d
CLOCK/ALARM
and scroll
to
m
DATE & TIME
, then press
.
DD/MM
m
and enter the time using the 24 hour format
e.g. 14:45 for 2.45pm.
m
>
to confirm or
to return to standby.
m
. Press
. Display shows
04/ 08
e.g.
for 4th August.
HH:MM
,
7