DiMarzio ANGEL PZ DP233 설치 지침

{카테고리_이름} DiMarzio ANGEL PZ DP233에 대한 설치 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. DiMarzio ANGEL PZ DP233 3 페이지.

페이지 인쇄

www.dimarzio.com

FIG. 1

FIG. 2A

FIG. 3

FIG. 4

Strings

THE ANGEL™ PZ DP233

INSTALLATION INSTRUCTIONS

The Angel™ PZ combines the Shadow Nanoflex undersaddle pickup with a specially

designed preamp. It includes a volume control mounted within the soundhole for easy

access. The preamp is powered by a 9-volt battery (not included), which is mounted in the

guitar on or near the neck block in a battery pouch. The Angel™ PZ works with standard

bronze strings, but nickel-wound and compound strings can also be used. It will also work

with nylon strings. [FIG. 1]

IMPORTANT: Installation of The Angel™ PZ is complex. We strongly recommend that

installation be done by a qualified guitar technician.

INCLUDED IN THIS PACKAGE

(1) Nanoflex undersaddle pickup

(1) The Angel™ PZ preamp module and endpin jack

(1) Self-stick dual volume control assembly

(1) Self-stick battery pouch

(1) 20-inch (51 cm) pickup-to-preamp cable

(1) 3⁄ 32 - inch Allen wrench

(4) Self-adhesive cable retainer clips

(1) Self-adhesive piezo cable retainer clip

(2) Alcohol wipes

(1) Instruction sheet

(1) Warranty card

Please read the installation instructions carefully. Installation of The Angel™ PZ requires the

use of the included preamp/endpin jack.

INSTALLING THE NANOFLEX UNDERSADDLE PICKUP

Measure the string height of the first and sixth strings before removing the strings and record

the measurements. Carefully remove the original saddle and drill a hole with a #42 drill bit

(0.093-inch or 2.40 mm) in the corner of the saddle slot at the bass string side of the bridge.

[SEE FIG. 2.] The hole must be drilled at an angle of 30° – 45°. Check the top bracing before

drilling the hole to avoid damage. Clean up the saddle slot and remove all wood dust and

chips. Route the pickup cable through the hole in the bridge from underneath the

bridgeplate and place the pickup into the saddle slot with "NFX top" showing. [FIG. 2A] To

restore the overall height of the bridge, reduce the height of the saddle by 1⁄ 32 inch (0.8 mm)

[FIG. 3] by sanding the bottom surface of the saddle. It is important that the bottom of the

saddle be absolutely flat.

FIG. 2

Cable

Retainer

Insert the saddle back into the slot and secure it temporarily with a piece of tape. Later, when

you restring the guitar, make sure the strings do not tilt the bridge saddle forward toward the

E 6

String

Drilled Hole

E 1

String