Motorola D200 series 사용자 설명서 - 페이지 10
{카테고리_이름} Motorola D200 series에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Motorola D200 series 28 페이지. D200 series digital cordless phone
Motorola D200 series에 대해서도 마찬가지입니다: 사양 시트 (2 페이지), 소유자 매뉴얼 (28 페이지)
페이지 인쇄
Allegro_CID.book Page 8 Tuesday, January 15, 2008 3:07 PM
6. Using your phone
Make a call
Press
. The
symbol is displayed. When you hear the
dial tone, dial the number you want. The number is shown in
the display.
After a short delay the call timer will start timing the call.
Adjust the earpiece/receiver volume
during a call
Press
or
to adjust the volume. There are five levels.
Preparatory dialling (pre-dial)
1. In standby mode, enter the number to be dialled.
The number is displayed.
You can enter numbers up to 32 digits. Press
any incorrect digits.
Press and hold
to delete all digits.
2. Press
to dial the displayed number.
Handset range
The handset range is up to 300 metres outdoors and up to
50 metres indoors (in ideal conditions).
If the handset is too far away from the base, during standby,
"Searching" appears and the
you will hear a warning tone and the call is terminated. You will
need to mover closer to the base for clearer reception and to
avoid being disconnected.
8
to delete
symbol will flash. During a call
Hands free mode
You can use hands free mode to talk to your caller without
holding the handset to your ear. You can speak into the
handset microphone and listen over the loudspeaker. Hands
free also enables other people in the room to listen in to the
conversation.
During a call:
1. Press
. The
symbol is displayed while in hands free
mode.
2. Press
again to go back to the normal talk mode.
Call timer
When you make or receive a call, a short while after the line is
connected the call timer will show the duration of the call in the
display in hours, minutes and seconds.
End a call
Press
.
Or
Place the handset back on the base.
Receive a call
When you receive a call the handset and base will ring. The
icon will flash in the handset display.
If you have subscribed to a caller ID service through your
network supplier, the caller's number will be displayed (if
available). If you store the number and name in the phonebook
and the number matches with that of the Caller ID, the Caller
name will appear and private ring will sound (if available). See
page 17 and 20 for further information on caller ID.
1. Press
or
to answer the call.