Motorola D210 series 사용자 설명서 - 페이지 27
{카테고리_이름} Motorola D210 series에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Motorola D210 series 32 페이지. Digital cordless phone
Motorola D210 series에 대해서도 마찬가지입니다: 사양 시트 (2 페이지)
페이지 인쇄
Allegro_CID TAD.book Page 25 Tuesday, January 15, 2008 4:30 PM
2. Press
or
to take the external call.
Transferring a call
You can transfer an external caller from your handset to
another internal handset.
During an external call:
1. Press
. The external caller is put on-hold.
2. Enter the number of the handset you want to transfer a call
with using the number keypad.
3. When the called handset answers, press
handset back on the base to transfer the call.
If the called handset does not answer, press
the external caller.
Conference call
You can hold a 3-way conversation (conference call) between
your handset, an external caller and another internal handset
user.
During an external call:
1. Press
. The external caller is put on-hold.
2. Enter the number of the handset you want to have a
conference call with using the number keypad. The called
handset will ring.
3. When the called handset answers, press
initiating handset to start your conference call.
4. Any handset can press
at any time to leave the
conference call.
15. Simple solutions
The most common problems often have the simplest
solutions. We hope that you will not experience any problems
with your product, but in the event that you do, this section
hopes to overcome any problems quickly and with minimum
effort.
Firstly, check that:
• the telephone line cord is correctly connected.
• the mains power cord is correctly connected and switched
on.
• the batteries are charged and not in need of replacing.
If you have more than one handset registered to your base
remember to check the connections on these too.
or place the
If you are still experiencing a problem, you are likely to find a
solution below.
to return to
Handset/Base
No dial tone
• Is the handset registered to the base? - see page 20.
• Is the
symbol flashing and can you hear a beep during a
call? - if so, move closer to the base as you are out of
range.
Cannot dial out
• Is
symbol displayed? - if so, the keypad lock is on, see
page 11.
Handset does not ring
on the
• The ringer volume may be set to off. - see page 18.
• Is the
symbol flashing? - if so, move closer to the base
as you are out of range.
Handset is not charging properly
• Check that the charge light is on and that the handset is
sitting correctly in the base. Clean the charging contacts
with a dry cloth.
25