Motorola D212 사용자 설명서 - 페이지 5
{카테고리_이름} Motorola D212에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Motorola D212 32 페이지. Digital cordless phone
Motorola D212에 대해서도 마찬가지입니다: 사양 시트 (2 페이지)
페이지 인쇄
Allegro_CID TAD.book Page 3 Tuesday, January 15, 2008 4:30 PM
1. Setting up
Follow these simple steps to prepare your phone ready for
use.
Finding a location
Make sure your phone is:
• Within 1.8 metres of a power and phone socket so that the
cords will reach.
• At least 1 metre away from other electrical appliances, to
avoid interference.
• Not located in humid or damp conditions, e.g. in a
bathroom.
Connecting your phone
Connect the base power supply into the socket on the back of
the base. Plug the other end into the mains power socket.
WARNING
Use only the power supply that came with your phone. Only
use the power supply TEN PAO G060040D25, 6V DC (center
plus mark) 400mA 2.4VA
Using another power supply could seriously damage your
phone and invalidate your warranty.
Do not connect the telephone line cord until your handset is
fully charged. This will prevent the risk of the phone being
answered before the batteries are charged. Answering the
phone before the batteries are fully charged may prevent them
from reaching their optimum capacity.
Preparing the handsets
Installing and charging the handset batteries
1. On the handset:
Remove the battery compartment cover.
Press down on the semi-circle indent and slide the cover off.
Connect the supplied batteries with the correct polarity.
Slide the battery cover back until it clicks securely into place.
2. To charge the battery, place the handset on the base. The
charging light in the base illuminates. When the handset is
fully charged all the bars of the battery symbol will be filled.
If the charging light does not come on, reposition the
handset in the base, ensuring that the charging points
contact.
You must charge each handset for 16-20 hours before use.
WARNING
Under no circumstances should non-rechargeable batteries be
used. Only use the supplied batteries or you will invalidate
your guarantee and may damage the telephone.
Battery low warning
If the empty battery symbol is displayed on the handset, or if
you hear the low battery tone during a call, you will need to
recharge your handset.
NOTE
If you set the "BATTERY LOW" tone to off, the low battery tone will
not sound.
We recommend that you place the handset back on the base
between use to ensure that it is always fully charged.
Battery Performance
The handset may become warm during charging, but this is
normal.
The handset will give 10 hours talk time and 170 hours standby
time on a full charge.
New NiMH batteries do not reach their full capacity until they
have been fully charged.
3