Motorola D501 사용자 설명서 - 페이지 6

{카테고리_이름} Motorola D501에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Motorola D501 39 페이지. D5 series
Motorola D501에 대해서도 마찬가지입니다: 사용자 설명서 (38 페이지), 매뉴얼 (44 페이지)

페이지 인쇄

1. Getting started

WARNING

Do not place your D5 in the bathroom or other humid areas.

Location

You need to place your D5 base within 2 metres of the mains

power and telephone wall sockets so that the cables will

reach. The socket-outlet shall be installed near the

equipment and shall be easily accessible.

Make sure that it is at least 1 metre away from other

electrical appliances to avoid interference. Your D5 works by

sending radio signals between the handset and base. The

strength of the signal depends on where you place the base.

Placing it as high as possible ensures the best signal.

HANDSET RANGE

The unit has a range of up to 300 metres outdoors when there

is a clear line of sight between the base and handset. Any

obstruction between the base and handset will reduce the range

significantly. With the base indoors and the handset either

indoors or outdoors, the range will normally be up to 50 metres.

Thick concrete and stone walls can severely affect the range.

SIGNAL STRENGTH

The

icon on your handset indicates that you are within

range of the base. When out of range of the base, the

icon flashes. If you are on a call, you will hear a warning

beep.

The line will hang up if the handset moves out of range of the

base. Move closer to the base. The handset will

automatically reconnect to the base.

Setting up

IMPORTANT

The base station must be plugged into the mains power at all

times. Do not connect the telephone line cord into the wall

socket until the handset is fully charged. Use only the power

adaptor and telephone line cord supplied with the product.

WHICH POWER ADAPTOR?

The power adaptor with a clear connecter is for the base unit

and the power adaptor with a red colour connecter is for the

charger unit (for multi-pack only).

Connecting the base

1. Plug the telephone line cord into the socket marked

on the underside of the base.

Getting started