Motorola E201 매뉴얼 - 페이지 9

{카테고리_이름} Motorola E201에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Motorola E201 44 페이지.

4. When the handset is fully charged,

Plug the other end of the telephone line cord (make sure that one end is

already plugged into the base) into the telephone wall socket.

Connecting the handset and charger (for multi-pack only)

If you have purchased a multiple pack, you will need to carry out this process for

all the handsets and chargers.

Plug the power adaptor into the socket marked

charger and plug the other end into the mains power wall socket.

2. Remove the battery cover from the back of the handset and insert the 2

x AAA Ni-MH rechargeable batteries supplied. Please note the '+' and '-'

markings inside the battery compartment and insert in the correct direction.

3. Slide the battery cover back into place.

4. If you are charging the batteries for the first time, place the handset on the

charger to charge for at least 16 hours continuously.

5. When the handset is fully charged,

The display will show

is registered to the base.

Important

Warning! Use only the approved rechargeable Ni-MH battery cells (2 x AAA Ni-MH

300mAh rechargeable batteries) supplied with your E2.

Battery low warning

icon flashes on the display and you hear a warning beep every minute during

a call, you will need to recharge the handset before you can use it again.

When charging,

Battery performance

In ideal conditions, fully charged batteries should give up to 10 hours talk time or

up to 200 hours standby time on a single charge.

Getting started

HANDSET

and handset number (e.g. 2) to indicate that it

icon will scroll on the display. Once charged scrolling will stop.

icon will appear steady on the display.

on the underside of the

icon will appear steady on the display.