Motorola ASTRO XTS-5000 운영 매뉴얼 - 페이지 4

{카테고리_이름} Motorola ASTRO XTS-5000에 대한 운영 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Motorola ASTRO XTS-5000 5 페이지. Motorola xts5000 portable radio
Motorola ASTRO XTS-5000에 대해서도 마찬가지입니다: 관리 및 문제 해결 매뉴얼 (2 페이지), 빠른 시작 매뉴얼 (4 페이지), 편집 매뉴얼 (3 페이지)

페이지 인쇄

To select a channel for scanning toggle the left or right 4-way Navigation Button

until the

desired channel is displayed. Press the "1 dot"

SEL select soft key. The

will appear

in the display indicating this channel is set to scan. To delete a channel from the scan list,

press the "2 dot"

DEL (delete) key. You can select up to 15 channels per System for

scanning. If you exceed 15 selections you will receive an error beep. Press the Home Button

to save your selections and return to normal operation.

NOTE: If you turn on the Scan function and you receive a low tone, and the display indicates

"EMPTY LIST," you have no channels programmed for scan. Turn off the scan switch and

program a scan list.

Emergency Button: When depressed, the Top Orange Button will send an emergency alert

to the Dispatch Center that your channel/talkgroup is assigned to along with your subscriber

unit number. You will be called immediately by Dispatch and asked the nature of your

emergency. If you have hit this button accidentally you must cancel it by holding it for two

seconds, or until the beeping goes away. You will still need to transmit the nature of the

emergency, or the error, to the Dispatcher so he/she can clear the alarm. The

Emergency button is to be used for EMERGENCIES only.

IMPORTANT: ALMR radios are NOT equipped with GPS. This means if you hit the

Emergency button (aside from lots of bells) no one knows your location or what your

emergency is. If you can move and talk, notify dispatch with a voice call and the nature of

your emergency.

Signal Strength and Coverage: There is a signal strength indicator on the display. If you are

out of range the indicator bars will drop to none and the radio will emit a long, repeating beep.

Move your location or try your vehicle radio.

Tone Mute Button: On the menu above there is a MUTE selection. When pressed, this

brings up the option to turn on/off the beep tone when any button is pressed.

Top Side Purple Button: This button turns the Display Lamp on/off.

Side Button #1: Used when someone is privately calling your radio and to monitor a

conventional/simplex channel. To monitor the channel, press and hold the side button #1 as

long as you want to monitor the channel.

Direct operation: The CONV (conventional) channels operate in Conventional/Simplex

mode. That is, local unit to local unit without going through the repeaters. This mode can be

used for local operations like traffic control or training, without tying up a repeater frequency.

Channel 8 in the State and Regional IC Zones is a conventional/simplex channel.

Site Switch:

NOTE: Your radio is programmed to automatically allow you to roam throughout the ALMR

System, much like a cell phone system, without any action on your part. However, there may

be times, such as when a site goes into SITE TRUNKING, when you may wish to have your

radio affiliate with a different repeater site.

Motorola XTS 5000 Portable Page

23Mar10