Motorola CM140 서비스 정보 - 페이지 9

{카테고리_이름} Motorola CM140에 대한 서비스 정보을 온라인으로 검색하거나 PDF를 다운로드하세요. Motorola CM140 26 페이지. Commercial series controlhead
Motorola CM140에 대해서도 마찬가지입니다: 사용자 설명서 (5 페이지)

페이지 인쇄
Motorola CM140 서비스 정보
Controlhead Model for CM140 and CM340
If the BOOT_RES (J802-7) line is connected to >5V (e.g. 9.3V) at turn-on, the uP will start in boot
mode instead of normal operation. This mode is used to programme new firmware into the FLASH
memory (U404 mainboard).
2.6

Speaker

The controlhead contains a speaker for the receiver audio. The receiver audio signal from the
differential audio output of the audio amplifier located on the radio's controller is fed via connector
J803-1, 2 to the speaker connector P801 pin 1 and pin 2. The speaker is connected to the speaker
connector P801. The controlhead speaker can be disconnected if an external speaker, connected on
the accessory connector, is used.
2.7

Electrostatic Transient Protection

Electrostatic transient protection is provided for the sensitive components in the controlhead by
diodes VR801, VR802, VR803 and VR804. The diodes limit any transient voltages to tolerable
levels. The associated capacitors provide Radio Frequency Interference (RFI) protection.
2-3