Motorola EMS APX 7500 사용자 설명서 - 페이지 6

{카테고리_이름} Motorola EMS APX 7500에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Motorola EMS APX 7500 44 페이지. Multiband mobile radio
Motorola EMS APX 7500에 대해서도 마찬가지입니다: 브로셔 (8 페이지), 제품 사양서 (5 페이지)

Motorola EMS APX 7500 사용자 설명서

Turning On the Radio

Press the Power On/Off Button
briefly to power on the radio.
After a short time, the red, yellow
and green LEDs light up. The
display then shows Zone and
channel text, and menu items
display on the screen.
The backlight will turn on to the last selected dim level.
Note:
Pressing the Power On/Off Button before the LED
lights up will be ignored.
If FAIL ##/## appears in the display, the radio will not
function until the condition has been corrected.
If ERROR ##/## appears, some non-critical data has
been changed. If either of these displays appear, if the
display goes blank, or if the unit appears to be locked
up, see Helpful Tips on page 111 for more
information.
If CH MISMATCH appears, means that either the
Control Head has been connected to an incompatible
transceiver, or vice versa.
English
Power On/
Off Button
To turn off the radio, press the Power On/Off Button after the
LEDs light up.
Validating Compatibility During Power Up
The radio validates and updates the software and hardware of
your control head(s) during power up. Follow the procedure
below when your radio runs this task.
Procedure:
1
The display shows MAINTENANCE MODE REMOTE DEVICE;
promptly followed by other maintenance statuses.
2
The display shows UPDATE DONE PLEASE RESET upon
completion.
OR
The display shows UPDATE FAILED PLEASE RESET when it
fails to update.
3
Press the Power On/Off Button to reset. The radio runs the
usual power up operation if the software updates are
complete.
OR
The radio runs the Maintenance Mode if the updates are not
complete and repeat step 1.
Note:
If SW INCOMPLETE appears, use Flashport Recovery
Tool to update the control heads before you power on
the radio again.
11/2/15
6