Motorola GM Series 설치 매뉴얼 - 페이지 21

{카테고리_이름} Motorola GM Series에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Motorola GM Series 36 페이지. Professional radio
Motorola GM Series에 대해서도 마찬가지입니다: 서비스 정보 (34 페이지), 서비스 매뉴얼 (28 페이지)

Motorola GM Series 설치 매뉴얼

Accessory Connections

6.0
Accessory Connections
6.1

Accessory Connector Pin Functions

This section gives a description of the accessory connector pin functions.
CAUTION: The accessory connections shown are not compatible to some other models of
!
Motorola radios. Check the appropriate accessory or technical manual for further
information.
Pin
Function
1
External
Speaker -
2
External Mic
Audio
3
Digital In 1
4
Digital Out 2
5
Flat_TX_Audio
(NPD Data Out)
6
Digital In 3
7
Ground
8
Digital In/Out 4
9
Digital In 5 with
Wakeup
Emergency
(NPD Call RQS)
10
Ignition Detect
Table 1-4 Connector Pin Functions
Speaker - and Speaker + (Pin 16) are used to connect an external speaker.
The audio PA is a bridge amplifier with a minimum load resistance of 3.2 Ω .
The internal speaker can be disabled by removing the control head.
Disconnect the internal speaker and assemble the control head back to the
radio.
External or Emergency Mic depends on dealer programming. This
microphone signal is independent of the microphone signal on the
microphone connector. The nominal input level is 80mV for 60% deviation.
The DC impedance is 660 Ω and the AC impedance is 560 Ω .
This is a digital input only and the primary use for this pin is external PTT. This
pin must be used if fast DATA PTT is required.
(See Note 1).
This is a digital output only and the primary use for this pin is as an external
alarm output (See Note 3).
This input is intended for injecting signals into the transmit path that should
not be filtered; for example, the analog output of a modem.
The nominal input level is 150mVrms for 60% deviation. The impedance is
greater than 25k Ω .
This is a digital input only. Function depends on dealer programming.
(See Note 4).
Used as ground for both analog and digital signals
This is a digital input/output depending on dealer programming.
(See Notes 1, 2).
This is a digital input only. Emergency can be enabled via the CPS. To
activate, this line must be connected to ground; this will turn on the radio. The
CPS details which functions may be assigned to this pin by the codeplug.
Connecting this line to the ignition line of the vehicle will automatically turn the
radio on when the ignition of the vehicle is turned on.
Description
1-13