Motorola GM1200E 설치 매뉴얼 - 페이지 12

{카테고리_이름} Motorola GM1200E에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Motorola GM1200E 36 페이지. Dealer programming software dps
Motorola GM1200E에 대해서도 마찬가지입니다: 사용자 설명서 (22 페이지), 설치 매뉴얼 (8 페이지)

페이지 인쇄

Radio Mounting

Locate the nearest available vehicle chassis ground mounting point and shorten the black

lead to remove excess cable length.

Install ring lugs (supplied) onto stripped end of power cable black lead, and onto stripped end

of red lead on fuse holder (see Figure 1-2).

Locate the fuse holder as close to the battery as possible and away from any hot engine

component. Mount the fuse holder via the mounting hole and dress wires as necessary.

Connect the fuse holder red adaptor lead plug to the mating receptacle on the red lead of the

power cable (see Figure 1-2).

Connect the power cable black lead directly to the vehicle chassis ground.

Connect the power cable red lead from the fuse holder to the positive (+) battery terminal.

Make sure the adaptor cable is connected to the main power cable red lead.

Plug fuse into in-line fuse holder (see Figure 1-2).

Note:

Failure to mount the red lead of the power cable kit directly to the battery may result in

severe alternator whine interference.

FIREWALL

Note:

If the Black Lead is connected to battery (-) terminal an additional 10A fuse in the black

lead should be implemented.

6.3

Mounting Trunnion Installation

Select the location to mount your radio either on the Transmission Hump or Under the Dash

(see Figure 1-5). By mounting the trunnion on the transmission hump take care the

transmission housing is not affected.

Using the trunnion mounting bracket as a template, mark the positions of the holes on the

mounting surface. Use the innermost three holes for a curved mounting surface such as the

transmission hump and the three outmost holes for a ﬂat surface such as under the dash.

Centre-punch the spots you have marked and drill a 4 mm Ø hole at each.

Secure the trunnion mounting bracket with the three screws provided. (see Figure 1-5)

Slide the radio into the trunnion. Secure the radio with the two thumb screws provided (see

Figure 1-3).

1-6

Adaptor

Red Lead

Black Lead

ENGINE COMPARTMENT

Figure 1-2 Power Cable Assembly.

Fuse

Red

Moulded In-line

Fuse Holder

Mtg. Hole

Chassis Ground

Cover

Red Lead

Ring Lugs

To batt (+)

To vehicle

Radio Installation