Motorola GP series 서비스 정보 - 페이지 8
{카테고리_이름} Motorola GP series에 대한 서비스 정보을 온라인으로 검색하거나 PDF를 다운로드하세요. Motorola GP series 30 페이지. Professional radio
Motorola GP series에 대해서도 마찬가지입니다: 서비스 매뉴얼 (26 페이지), 서비스 정보 (24 페이지), 서비스 정보 (31 페이지), 서비스 정보 (43 페이지), 사용자 설명서 (16 페이지), 매뉴얼 (30 페이지)
페이지 인쇄
1-4
A MOSFET Q416 switches in the LiO supply when Vdd is removed. Q416 also provides isolation
from BOOT_CTRL function in the event of radio program flashing. The 3.3V regulator charges the
Lithium battery.
3.4
ModB/Vstby Supply
The supply to the ModB/Vstby pin varies depending on the conditions listed in Table 1-2.
Radio On
Radio Off
Primary battery removed
Flash Mode
3.5
Audio/Signalling Architecture
( Refer to Figure 1-2 and the ASFIC/ON_OFF and Audio Power Amplifier schematic diagrams )
The audio/signalling/filter/companding IC (ASFIC_CMP) and the audio power amplifier, shown in
Figure 1-2, form the main components of the audio/signalling architecture section of the controller
board. Inputs include a 16.8 MHz clock from the synthesizer, recovered audio and squelch, MCU
control signals, and external or internal microphones. Outputs include a microprocessor clock (uP),
modulator output to the synthesizer, and amplified audio signals to an internal or external speaker.
Table 1-2 ModB/Vstby Supply Modes
Condition
Circuit Operation
Vdd supply voltage via CR411
• Vdd turned off
• Q416 gate pulled low by R462
• Q416 switched on
• U410 supplies 3.2V to ModB/Vstby
• Vdd turned off
• Q416 gate pulled low by R462
• Q416 switched on
• Lithium battery provides 3.2V to ModB/Vstby
• Boot_Ctrl line pulled low
• ModA & ModB go low
• Processor in boot-strap mode
THEORY OF OPERATION