Motorola GP1280 Series 기본 서비스 매뉴얼 - 페이지 17
{카테고리_이름} Motorola GP1280 Series에 대한 기본 서비스 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Motorola GP1280 Series 46 페이지. Professional radio, power distribution and controller
Motorola GP1280 Series에 대해서도 마찬가지입니다: 서비스 정보 (32 페이지), 서비스 정보 (30 페이지), 서비스 정보 (30 페이지)
페이지 인쇄
Repair Procedures and Techniques — General
4.0
Repair Procedures and Techniques — General
Parts Replacement and Substitution
When damaged parts are replaced, identical parts should be used. If the identical replacement part
is not locally available, check the parts list for the proper Motorola part number and order the part
from the nearest Motorola Communications parts center listed in the "Piece Parts" section of this
manual.
Rigid Circuit Boards
This family of radios uses bonded, multi-layer, printed circuit boards. Since the inner layers are not
accessible, some special considerations are required when soldering and unsoldering components.
The printed-through holes may interconnect multiple layers of the printed circuit. Therefore, exercise
care to avoid pulling the plated circuit out of the hole.
When soldering near the 20-pin and 40-pin connectors:
Avoid accidentally getting solder in the connector.
Be careful not to form solder bridges between the connector pins.
Examine your work closely for shorts due to solder bridges.
Flexible Circuits
The flexible circuits are made from a different material than the rigid boards, and require different
soldering techniques. Excessive prolonged heat on a flexible circuit can damage the material.
Therefore, avoid excessive heat and excessive bending.
For parts replacement, use the ST-1087 Temperature-Controlled Solder Station with a 600-700
degree tip, and use small diameter solder such as ST-633. The smaller size solder will melt faster
and require less heat to be applied to the circuit.
To replace a component on a flexible circuit:
1.
Grasp with seizers (hemostats) the edge of the flexible circuit near the part to be removed.
2.
Pull gently.
3.
Apply the tip of the soldering iron to the component connections while pulling with the seizers.
NOTE
Do not attempt to puddle-out components. Prolonged application of heat may damage the
flexible circuit.
5.0
Disassembling and Reassembling the Radio — General
Since these radios may be disassembled and reassembled with the use of only four (board to
casting) screws, it is important to pay particular attention to the snaps and tabs, and how parts align
with each other.
The following tools are required for disassembling the radio:
Small flat blade screwdriver
penknife-size screwdriver
TORX™ T6 screwdriver
3-3