Motorola MaxTrac 100 사용 설명서 - 페이지 29
{카테고리_이름} Motorola MaxTrac 100에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Motorola MaxTrac 100 37 페이지. 6-frequency conventional fm radio
Motorola MaxTrac 100에 대해서도 마찬가지입니다: 운영 지침 (2 페이지)
페이지 인쇄
(4) Locate the nearest available vehicle chassis-ground mounting point and
shorten the black led to remove excess cable length.
(5) Install ring lugs (supplied) onto the stripped end of the power cable black
lead. Also install a ring lug onto the stripped end of the red lead on the fuse
holder as shown in Figure 2.
(6) Locate the fuse holder as close to the battery as possible and away from any
hot-engine component. Mount the fuse holder using the provided mounting
hole and dress wires as necessary. Connect the fuse holder red-adapter-lead
plug to the mating receptacle on the red lead of the power cable as shown in
Figure 2.
ADAPTER
RED LEAD
FIREWALL
BLACK LEAD
(7) Connect the power cable black lead directly to the vehicle chassis ground.
(8) Connect the power cable red lead from the fuse holder to the positive (+)
battery terminal. Make sure the adapter cable is connected to the main
power cable red lead.
Note: Failure to mount the red lead of the power cable kit directly to the
battery may result in severe alternator-whine interference and cause the
radio to revert to mode one each time the power is turned off.
RED
MOLDED IN-LINE
FUSE HOLDER
MTG. HOLE
ENGINE COMPARTMENT
Figure 2. DC Power Cable Assembly
FUSE
COVER
RED LEAD
RING LUGS
TO BATTERY (+)
TO VEHICLE
CHASSIS GROUND
Begin Installation (cont.)
DC Power Cable Installation (cont.)
27