Motorola MCS 2000 설치 매뉴얼 - 페이지 12
{카테고리_이름} Motorola MCS 2000에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Motorola MCS 2000 14 페이지.
Motorola MCS 2000에 대해서도 마찬가지입니다: 사용자 설명서 (20 페이지), 개조 지침 (11 페이지)
페이지 인쇄
5-2
The Siren/PA Options screen enables you to modify various Siren/PA options (default settings are
indicated). The following tables describe the programmable fields and their settings:
Field
Options Audio Muting
PA Ignition Sense
Ext Radio Ignition
Default PA Volume Level
Siren P/A After Reset
*Not available in initial offering. See Table 1-1, "Siren/PA Features," on page 1-2.
Field
Hi-Lo Airhorn Tones
Manual Tone
Siren Ignition Sense
December 2, 2003
Table 5-1. Public Address Fields
Disabled (default): Routes all audio to the Public Address speaker when in
External Radio Mode.
Enabled: Prevents deciphered SECURENET® audio and Mobile Voice
Storage message playback from being heard over the external speaker.
Disabled (default): Public Address operable with ignition switch on or off.
Enabled: Public Address operable only with ignition switch on.
Disabled (default): External Radio operable with ignition switch on or off.
Enabled: External Radio operable only with ignition switch on.
This field is programmed to set the Public Address volume level for initial
power-up. If no volume level is manually selected by the operator, the
volume will default to the setting in this field.
The range is from 0 to 15 (default 11).
LAST STATE* (default): The siren will power up in the same state, on or off,
as at power-down (Warm Start).
Off: Siren will always be off at power-up.
Table 5-2. Siren Fields
Disabled: Hi-Lo and Airhorn tones cannot be produced.
Enabled (default): Hi-Lo and/or Airhorn tones are allowed.
This field selects the Manual Tone that will be heard when the Horn-Ring is
pressed. The choices are Ar Hn, Wail, or Yelp (default is Wail).
Disabled: Siren tones operable with the ignition switch on or off.
Enabled (default): Siren tones operable with ignition switch on.
Options
Options
CPS Programming:
6881096C46-O