Motorola PTX600 사용자 설명서 - 페이지 14

{카테고리_이름} Motorola PTX600에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Motorola PTX600 20 페이지.

페이지 인쇄

LED lights while the radio transmits and ﬂashes if

the channel is busy.

Some channels may be monitored for activity by

pressing the clear button (6). The icon will be lit until

the channel is changed or the clear button (6) is

pressed again.

In the conventional mode the radio is equipped with

a maximum transmit duration timer. This is

programmed to start whenever the PTT is pressed.

Tone G sounds ﬁve seconds before the transmitter

is switched off. If the timer expires whilst still

transmitting, transmission will cease and a

continuous fail tone will sound until the PTT is

released.

Accessories and Battery Care

Fitting Belt Clip

Refer to illustration 1 on page (iii).

To ﬁt the belt clip, slide it into the mounting rails on

the back of the radio and press it downwards until it

latches into place. To remove the belt clip, lift the

release tab by inserting a key or coin between the

release tab and the back of the radio. Press the belt

clip upwards until it is completely disengaged from

the radio.

English

Fitting Belt Clip/Fitting Battery/Operating Time

Fitting/Removing Battery

Refer to illustrations 2 and 3 on page (iii).

To ﬁt the battery, slide it into the control rails about 1/

2 an inch (2 cm) from the top of the radio and slide it

towards the top until the battery latch has engaged.

Before removing the battery, turn off the radio.

Press the battery latch towards the front of the radio,

slide the battery down about 1/2 an inch (2 cm) and

lift it away from the radio.

Note: The battery must be charged before initial

use. (For approximately 16 hours)

Operating Time

The operating time depends on the battery capacity,

transmit power combined with the frequency band,

and the duty cycle.

When the battery voltage runs low the battery icon

will appear on the display (display radios only)

and the low battery warning tone will sound

repeatedly for 60 seconds.

The power level in trunked mode can be adjusted on

the keypad radio which will save the battery life. To

toggle between high and low power levels enter

"14

". The display indicates the power level

selected by displaying the LO icon when low power

is selected.

2-Year Warranty